Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
10.1. Features of a design
10.2. Assembly blocks
10.3. Rechargeable battery
10.4. Generator
10.5. Starter
10.6. Switch (lock) of ignition
10.6.1. Features of a design
10.6.2. Check of the switch (lock) of ignition
10.6.3. Replacement of contact group of the switch (lock) of ignition
10.6.4. Removal and installation of the switch (lock) of ignition
10.7. Control system of the engine
10.8. Lighting, light and sound alarm system
10.9. Replacement of a motor-reducer of a screen wiper of a wind window
10:10. Removal and installation of a washer of glass of a wind window
10:11. Removal and installation of the electric motor of the main fan of a radiator of the cooling system of the engine
10:12. Removal and installation of the electric motor of the additional fan of a radiator of the cooling system of the engine
10:13. Back window glass electrical heating
10:14. Removal and installation of the boss of the lighter
10:15. Combination of devices
10:16. Dashboard switches
10:17. Replacement of control units of electrowindow regulators
10:18. Automobile audio system
10:19. Replacement of sensors and switches
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








59d80679


10-6-4-snyatie-i-ustanovka-vyklyuchatelya-zamka-zazhiganiya.html

10.6.4. Removal and installation of the switch (lock) of ignition

The switch (lock) of ignition is installed on a steering column and fixed by two bolts with the self-cutting-off heads therefore for its replacement bolts need to be removed with a chisel or to drill the electric drill. The switch (lock) of ignition can be changed, without removing a steering column, but for convenience you can remove it (see. "Removal and installation of a steering column").
It will be required to you: screw-drivers with flat and crosswise edges, a chisel, the hammer.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove casings of a steering column (see. "Replacement of contact group of the switch (lock) of ignition").
3. Turn out a bolt of fastening of the switch, striking blows with the hammer through a chisel to a tangent counterclockwise.
4. Similarly turn out the second bolt …
5. … also remove the switch (lock) of ignition.
6. Turn out the fastening screw …
7. … also remove contact group.
8. Insert a key into the switch (lock) of ignition and turn it in the provision of "ACC".
9. Press a clamp …
10. … also take the lock cylinder from the case of the locking device.
11. Establish details as it should be, the return to removal.

"previous page
10.6.3. Replacement of contact group of the switch (lock) of ignition
following page"
10.7. Control system of the engine