10-8-2-zamena-lamp.html
10.8.2. Replacement of lampsFor replacement of lamps of a block headlight execute the following operations.
1. Open a cowl.
2. Disconnect a wire from the minus plug of the rechargeable battery...
|
|
3. … turn a headlight cover counterclockwise …
|
4. … also uncover.
|
NOTES
Replacement of lamps of a left headlight is shown. Lamps in a right headlight are symmetrized, replace them similarly.
The cover of a headlight is condensed with a rubber ring. Replace strongly pressed out or torn ring new.
|
|
|
5. Disconnect a block of a plait of wires from a lamp of passing/driving beam.
|
6. Bring a spring clamp out of hooks on a reflector, cast away a clamp...
|
7. … also take out a lamp of head light.
PREVENTION
Do not touch by lamp flask fingers as the galogenovy lamp strongly heats up and fatty spots will cause darkening of a flask. Take a lamp for a flask only in pure gloves or a pure rag. If on a lamp after all there were fatty spots, remove them with alcohol.
|
8. Insert a new lamp into a reflector and record it the spring holder.
|
|
9. Extend a cartridge of a lamp of dimensional light from a nest (the boss is established with a small tightness) and take it from a block headlight.
|
10. Take a bestsokolny lamp from the boss.
|
11. Insert a new lamp into a cartridge and establish a cartridge into place.
12. Establish into place a headlight cover.
|
|
13. Turn a cartridge of a lamp of the index of turn counterclockwise …
|
14. … also take it from a block headlight.
|
15. Press a lamp, turn it counterclockwise and take from the boss.
16. Establish a new lamp in a cartridge, and a cartridge in a block headlight.
For replacement of a lamp of a side lamp of indexes of turn execute the following operations.
1. Disconnect a wire from the minus plug of the rechargeable battery.
|
|
2. Shift the case of the index of turn back …
|
3. … also take it from a wing.
|
|
|
4. Turn a cartridge counterclockwise …
|
5. … also take it from an index lamp.
|
6. Take a lamp from the boss.
7. Insert a new lamp into a cartridge, and a cartridge in the index case.
8. Establish a side lamp of indexes of turn as it should be, the return to removal.
For replacement of any lamp in a back lamp execute the following operations.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Open a luggage carrier.
|
|
3. Squeeze clamps and open a cover in facing of a luggage carrier for access to a lamp.
|
4. Turn a cartridge of a lamp counterclockwise …
|
|
|
5. … also take it from a lamp.
|
6. Press a lamp, turn it counterclockwise and take out from the boss.
|
7. At installation of a new lamp ledges on a lamp have to get to cuts on the boss. Then record a lamp in the boss, having turned it against the stop (on 90 °) clockwise.
8. Establish details as it should be, the return to removal.
9. Other lamps in a back lamp replace similarly.
For replacement of a lamp in a lamp of illumination of registration plate execute the following operations.
1. Disconnect a wire from the minus plug of the rechargeable battery.
|
|
|
3. Take a bestsokolny lamp from the boss.
|
4. Establish a new lamp.
5. Establish details as it should be, the return to removal.
For replacement of a lamp in an additional stoplight execute the following operations.
1. Disconnect a wire from the minus plug of the rechargeable battery.
|
|
2. Turn a cartridge of a lamp of an additional stoplight counterclockwise and remove it (operation is performed from a luggage carrier).
|
3. Press a lamp, turn it counterclockwise and take out from the boss.
|
4. Establish details as it should be, the return to removal.
NOTE
One of ledges on the boss of a lamp of the already others. At installation orient a cartridge so that it coincided with narrower cut (it is shown by an arrow), and turn a cartridge clockwise against the stop.
|
For replacement of a lamp in a plafond of illumination of salon execute the following operations.
1. Disconnect a wire from the minus plug of the rechargeable battery.
|
|
2. Wring out the screw-driver clamps and remove the lens of a plafond.
|
3. Wring out spring contact and take a lamp.
|
4. Insert a new lamp.
|
|
5. Install at first a forward part of the lens in the plafond case …
|
6. … and then press a back part before click (a zashchelkivaniye of clamps).
|
For replacement of a lamp in a plafond of illumination of a luggage carrier execute the following operations.
1. Disconnect a wire from the minus plug of the rechargeable battery.
|
|
2. Overcoming effort of a clamp, take a plafond from an opening in a car body (if necessary hook it the screw-driver).
|
3. Wring out spring contact and take a lamp.
|
4. Insert a new lamp into a plafond.
5. Establish details as it should be, the return to removal.
|