11-13-snyatie-i-ustanovka-oblicovki-tonnelya-pola.html
11:13. Removal and installation of facing of a tunnel of a floorFacing of a tunnel of a floor consists of two parts: forward and back.
You will need the screw-driver with a crosswise edge.
|
|
1. Turn out two screws behind a back part of facing at the left …
|
2. … and on the right.
|
NOTE
The seat of the driver is removed for descriptive reasons. For receiving access to fastenings of facing it is not required to remove a seat.
|
|
|
3. Lift the lever of the parking brake up, shift a little back part of facing back, bringing its clamps out of gearing with a forward part …
|
4. … also remove it, having moved on the lever of the parking brake up and forward.
|
NOTE
For removal of a forward part of facing of a tunnel of a floor it is optional to remove a back part, it is enough to turn out screws of its fastening and to shift a little back.
|
|
|
5. Take from a forward part of facing of a tunnel of a floor a control lever cover frame the transmission, overcoming effort of its clamps.
|
6. Through a window for installation of a cover of a control lever the transmission separate a block of a plait of wires of the lighter.
|
|
|
7. Turn out one screw of fastening behind a forward part of facing …
|
8. … and two screws ahead.
|
NOTE
The second screw of fastening of a forward part of facing of a tunnel of a floor is symmetrized rather longitudinal axis of the car.
|
9. Develop a control lever cover frame the transmission so that it passed in an opening of a forward part of facing of a tunnel of a floor, and remove a forward part of facing.
10. Establish parts of facing of a tunnel of a floor as it should be, the return to removal.
|
|