Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and flaps
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box of airinflow
11.8. Cowl
11.9. Doors
11:10. Trunk lid
11:11. Cover of the hatch of a bulk pipe of the fuel tank
11:12. Seats
11:13. Removal and installation of facing of a tunnel of a floor
11:14. System of passive safety (SRS)
11:15. Rear-view mirrors
11:16. Dashboard
11:17. Heater and conditioner
11.17.1. Features of the device
11.17.2. Removal and installation of the control unit of system of heating and conditioning
11:18. Fittings of salon
11:19. Removal and installation of facings of salon
11:20. Removal and installation of facings of a luggage carrier
11:21. Screen wiper of a wind window
11:22. Replacement of a motionless glazing of a body
11:23. Removal and installation of the shelf of fastening of the rechargeable battery
11:24. Care of a body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








59d80679


11-17-2-snyatie-i-ustanovka-bloka-upravleniya-sistemojj-otopleniya-i-kondicionirovaniya.html

11.17.2. Removal and installation of the control unit of system of heating and conditioning

It will be required to you: screw-drivers with flat and crosswise edges.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Having wrung out the screw-driver spring clamps on both sides of a facing overlay of the console of the dashboard above …
3. … and below, remove a slip.
4. Turn out two screws of fastening of a cap of boxing for installation of the radio tape recorder …
5. … take away a cap from the dashboard, disconnect a block of a plait of wires from a cap, take out a cable of the antenna from the holder and remove a cap.
6. Take from a dashboard nest boxing for installation of the radio tape recorder.
7. Turn out two screws of fastening to the dashboard of the control unit of system of heating and conditioning …
8. … bring three clamps in the top part of the block out of gearing with the dashboard and move the block on yourself so as far as length of wires and drafts allows.
9. Disconnect from the block of a block of a plait of wires.
10. Having wrung out a finger a clamp of a cover of draft of control of the gate of distribution of streams of air …
11. … disconnect a cover from the case of a heater and remove draft from a gate lever finger.
12. Similarly disconnect draft of control of gates of regulation of temperature of the air coming to salon from heater levers …
13. … and recirculation gate.
14. Remove the control unit of system of heating and conditioning together with drafts. If necessary disconnect from levers of the block of draft the same as it was done at their detachment from heater levers (see subitem 11-14).
15. Install the control unit of heating and conditioning and all removed details as it should be, the return to removal.

"previous page
11.17.1. Features of the device
following page"
11:18. Fittings of salon