11-9-1-snyatie-i-ustanovka-obivki-perednejj-dveri.html
11.9.1. Removal and installation of an upholstery of a forward doorIt will be required to you: screw-drivers with crosswise and flat edges.
1. Disconnect a wire from the minus plug of the rechargeable battery.
|
|
2. Turn out the screw of fastening of facing of an armrest …
|
3. … shift facing back to bring its clamp out of gearing with an armrest...
|
|
|
4. … also take facing from an armrest nest.
|
5. Disconnect a block of a plait of wires from the control unit of electrowindow regulators installed in facing and remove facing.
|
|
|
6. Remove a decorative overlay of a support of an external rear-view mirror, overcoming resistance of its clamps.
|
7. Having hooked the screw-driver …
|
GOOD ADVICE
Not to scratch a detail, wrap up a screw-driver sting an insulating tape.
|
|
|
8. … remove facing of the internal handle of the lock.
|
9. Turn out three screws of fastening of an upholstery to the lower edge of a door.
|
10. Disconnect an upholstery from the door panel, overcoming effort of percussion caps.
NOTE
The door upholstery (view from a reverse side) is attached to the door panel by five plastic percussion caps. Replace the damaged percussion caps new, having taken out them from upholstery arms.
If necessary remove a pocket from an upholstery, having turned out seven screws of its fastening.
|
|
|
11. Turn out two screws of fastening of an arm of an armrest to the panel of a door and remove an arm.
|
12. Unstick a moisture protective film from the door panel.
|
13. Establish an upholstery of a back door and all removed details as it should be, the return to removal.
NOTE
At installation of an arm of an armrest of the shooter, vyshtampovanny on it, it has to be directed in the direction of the movement of the car forward.
|
|
|