11-9-10-snyatie-i-ustanovka-obivki-zadnejj-dveri.html
11.9.10. Removal and installation of an upholstery of a back doorIt will be required to you: screw-drivers with crosswise and flat edges.
1. Having hooked the screw-driver, remove facing of the internal handle of the lock.
GOOD ADVICE
Not to scratch a detail, wrap up a screw-driver sting an insulating tape.
|
|
|
2. Turn out the screw of fastening of facing of a nest in a door armrest …
|
3. … also remove facing.
|
|
|
4. Wring out the window regulator handle socket to a door upholstery …
|
5. … through the formed gap take a spring clamp of the handle, having hooked it the screw-driver …
|
|
|
6. … also remove the handle of a window regulator and its socket.
|
7. Remove facing of a corner of a back door, overcoming effort of two of her spring holders.
|
|
|
8. Turn out two screws of fastening of an upholstery to the lower edge of a door.
|
9. Having hooked the screw-driver an upholstery in the locations of its plastic percussion caps …
|
NOTE
The upholstery (view from a reverse side) is attached to the door panel by five plastic percussion caps. Replace the damaged percussion caps new, having taken out them from upholstery arms.
If necessary remove from an upholstery a porolonovy sealing ring and the window regulator roller.
|
|
|
10. … disconnect an upholstery from the door panel, overcoming effort of percussion caps.
|
11. Turn out two screws of fastening of an arm of an armrest to the panel of a door and remove an arm.
|
12. Unstick a moisture protective film from the door panel.
13. Establish an upholstery of a back door and all removed details as it should be, the return to removal.
NOTE
At installation of an arm of an armrest of the shooter, vyshtampovanny on it, it has to be directed in the direction of the movement of the car forward.
|
|
|