Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and flaps
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box of airinflow
11.8. Cowl
11.9. Doors
11.9.1. Removal and installation of an upholstery of a forward door
11.9.2. Replacement of glass of a forward door
11.9.3. Replacement of a window regulator of a forward door
11.9.4. Replacement of the external handle of a forward door
11.9.5. Replacement of the internal handle of the drive of the lock of a forward door
11.9.6. Replacement of the switch of the lock of a forward door
11.9.7. Replacement of the lock of a forward door
11.9.8. Replacement of the limiter of opening of a forward door
11.9.9. Removal and installation of a forward door
11.9.10. Removal and installation of an upholstery of a back door
11.9.11. Replacement of glass of a back door
11.9.12. Replacement of a window regulator of a back door
11.9.13. Replacement of the external handle of a back door
11.9.14. Replacement of the internal handle of the drive of the lock of a back door
11.9.15. Replacement of the lock of a back door
11.9.16. Replacement of the limiter of opening of a back door
11.9.17. Removal and installation of a back door
11:10. Trunk lid
11:11. Cover of the hatch of a bulk pipe of the fuel tank
11:12. Seats
11:13. Removal and installation of facing of a tunnel of a floor
11:14. System of passive safety (SRS)
11:15. Rear-view mirrors
11:16. Dashboard
11:17. Heater and conditioner
11:18. Fittings of salon
11:19. Removal and installation of facings of salon
11:20. Removal and installation of facings of a luggage carrier
11:21. Screen wiper of a wind window
11:22. Replacement of a motionless glazing of a body
11:23. Removal and installation of the shelf of fastening of the rechargeable battery
11:24. Care of a body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








59d80679


11-9-9-snyatie-i-ustanovka-perednejj-dveri.html

11.9.9. Removal and installation of a forward door

You will need a face head "on 10".
1. Remove an upholstery of a forward door and a moisture protective film (see. "Removal and installation of an upholstery of a forward door").
2. Disconnect the limiter of opening of a door from a forward rack (see. "Replacement of the limiter of opening of a forward door").
3. If you remove a door not for replacement, mark the provision of its loops on a door (for example, lead round loops on a contour a felt-tip pen).
4. Holding a door (it is the best of all if it is done by the assistant), turn out two bolts of fastening to a door top …
5. … and lower loops also remove a door.
    
NOTE
Bolts of fastening of loops to a rack of a body are remote therefore for removal of a forward door it is necessary to turn out only bolts of fastening of loops to a door. In need of installation of loops on a new door remove them from a rack after removal of a door.

6. Establish a forward door as it should be, the return to removal.

"previous page
11.9.8. Replacement of the limiter of opening of a forward door
following page"
11.9.10. Removal and installation of an upholstery of a back door