Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
3.1. The engine is not started
3.1.1. General methods of launch of the engine
3.1.2. Malfunctions in system of start-up
3.1.3. Check of system of ignition
3.1.4. Check of a power supply system of the engine
3.2. Malfunctions of system of injection of fuel
3.3. Idling was gone
3.4. Interruptions in operation of the engine
3.5. Diagnostics of a condition of the engine on appearance of spark plugs
3.6. The car moves breakthroughs
3.7. The car badly accelerates
3.8. The engine decayed during the movement
3.9. Oil pressure fell
3.10. Engine overheat
3.11. The rechargeable battery is not recharged
3.12. Launch of the engine from external sources of current
3.13. Malfunctions of electric equipment
3.14. There were foreign knocks
3.15. Problems with brakes
3.16. Wheel puncture
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment



3.1.1. General methods of launch of the engine

Methods of launch of the engine with system of injection of fuel same at any temperature of external air and liquid in the engine cooling system.
For start-up it is only enough to include a starter, without touching an accelerator pedal. The control system of the engine will independently set parameters of supply of fuel and an advancing of ignition, necessary for start-up.
1. Open a cowl, having pulled on themselves the handle of the drive of its lock.
2. Measure by the Masloizmeritelny probe oil level. It has to be between tags of "MAX" and "MIN".
3. Check levels brake …
4. … and cooling liquids.
5. Attentively examine the engine and podkapotny space. Pay attention on begin to flow gasoline, oil, the brake and cooling liquids. Be convinced of integrity of an electrical wiring. Check landing of high-voltage wires in ignition coil nests, on candles.
6. Without closing a cowl (in case of a rain or snowfall cover it), you take the wheel. Include ignition, having turned a key in the ignition switch in the provision of "ON". At the same time the electrogasoline pump will join. Launch the engine, having turned a key in the ignition switch in situation "START".

It is better to close a cowl after the engine begins to work. Before it it is desirable to examine once again the engine, to be convinced of lack of leaks of fuel, oil, cooling liquid, and also foreign sounds in its work.
If for any reason during unsuccessful attempt of start-up spark plugs "are filled in", use the mode of a purge of cylinders. For this purpose press an accelerator pedal against the stop and include a starter. In this mode supply of fuel is absent and from cylinders a stream of fresh air excess gasoline is removed — spark plugs dry. After a purge repeat start-up attempt regularly.

If the engine was not started, there are three main reasons:
– the system of start-up does not work;
– the system of ignition does not work;
– the power supply system does not work.

Besides the listed main reasons, the engine can not be launched at malfunction of the valve of a purge of an adsorber or owing to an air suction through connections of hoses of system of catching of vapors of fuel.

"previous page
3.1. The engine is not started
following page"
3.1.2. Malfunctions in system of start-up