Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
3.1. The engine is not started
3.1.1. General methods of launch of the engine
3.1.2. Malfunctions in system of start-up
3.1.3. Check of system of ignition
3.1.4. Check of a power supply system of the engine
3.2. Malfunctions of system of injection of fuel
3.3. Idling was gone
3.4. Interruptions in operation of the engine
3.5. Diagnostics of a condition of the engine on appearance of spark plugs
3.6. The car moves breakthroughs
3.7. The car badly accelerates
3.8. The engine decayed during the movement
3.9. Oil pressure fell
3.10. Engine overheat
3.11. The rechargeable battery is not recharged
3.12. Launch of the engine from external sources of current
3.13. Malfunctions of electric equipment
3.14. There were foreign knocks
3.15. Problems with brakes
3.16. Wheel puncture
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








59d80679


3-1-3-proverka-sistemy-zazhiganiya.html

3.1.3. Check of system of ignition

PREVENTION
On your car the microprocessor system of ignition (MPSZ) of high energy is installed. Voltage about 40 000 V is brought to high-voltage wires and though at small current it is harmless for life, the possible blow by current when checking system of ignition can lead to serious consequences. Therefore if you undertake a high-voltage wire at the included ignition, use a thick rubber glove or as a last resort passatizham with the isolated handles.

    
GOOD ADVICE
Before check of system of ignition install the gear shifting lever in neutral situation and leave included in the parking brake.

1. At the switched-off ignition check an integrity and landing of high-voltage wires in ignition coil nests.
2. Check serviceability of the coil of ignition (see. "Check of the coil of ignition").
3. If the low-voltage chain of the coil of ignition is serviceable, check existence of a spark on spark plugs. Remove a high-voltage wire from any spark plug. Insert a spare spark plug into a wire tip and press it a metal part to "mass" of the car (for example, to an inlet pipe). Ask the assistant to turn a starter a bent shaft of the engine.

    
PREVENTIONS
The reliable contact of the case of a candle with "weight" is obligatory as at emergence of an additional spark interval, bigger, than a gap between candle electrodes, damage of the block of a control system of the engine or a high-voltage chain of the coil of ignition is possible.
You carry out the specified inspection no more than five seconds not to damage converter of the fulfilled gases at hit in it the gasoline engine which did not burn down in cylinders.

4. If there is no spark, replace high-voltage wires new. It is possible previously to try to establish old, but checked, from "the working car".
5. If after replacement of wires the spark did not appear, replace the ignition coil (see. "Removal and installation of the coil of ignition"). If the spark is, but the engine is not started, replace spark plugs new. It is possible previously also to try to establish old, but checked, from "the working car".
6. If after that the engine is not started, check serviceability of a control system of the engine (see. "Malfunctions of system of injection of fuel").

"previous page
3.1.2. Malfunctions in system of start-up
following page"
3.1.4. Check of a power supply system of the engine