4-3-14-proverka-tekhnicheskogo-sostoyaniya-detalejj-perednejj-podveski-na-avtomobile.html
4.3.14. Check of technical condition of details of a forward suspension bracket on the carYou carry out all checks and works from below the car installed on the elevator or a viewing ditch (with the hung-out forward wheels).
At each maintenance and repair it is necessary to check a condition of protective covers of spherical support of a suspension bracket, on covers there should not be mechanical damages.
Find out whether is not present on details of a suspension bracket of cracks or traces of a zadevaniye against road obstacles or a body, deformation of levers, bars of the stabilizer and its racks, body front details in places of fastening of knots and details of a suspension bracket.
Check a condition of rubber-metal hinges, rubber pillows, spherical hinges of a suspension bracket, and also a condition (draft) of the top support of telescopic racks of a suspension bracket.
Rubber-metal hinges and rubber pillows are subject to replacement at gaps and a unilateral vypuchivaniye of rubber, and also when cutting their face surfaces.
|
Fig. 4.2. An arrangement of elements of a forward suspension bracket on the car: 1 – forward hinge (saylentblok) of the lever of a forward suspension bracket; 2 – damping rack; 3 – spring of a forward suspension bracket; 4 – spherical support of a rack; 5 – rack of the stabilizer of cross stability; 6 – bar of the stabilizer of cross stability; 7 – back hinge (saylentblok) of the lever of a forward suspension bracket; 8 – lever of a forward suspension bracket
|
The arrangement of elements of a forward suspension bracket on the car is shown in fig. 4.2.
On rubber details of a suspension bracket are not allowed:
– rubber aging signs;
– mechanical damages.
On rubber-metal hinges are not allowed:
– signs of aging, crack, unilateral vypuchivaniye of the rubber massif;
– lead of the rubber massif over fittings.
Replace faulty details.
PREVENTION
Pay special attention to mechanical damages (deformations, cracks and so forth) suspension bracket elements, especially levers.
|
|
|
1. Check a condition of protective covers of spherical support. If covers are damaged, replace spherical support assembled.
|
2. Shaking a wheel in the vertical plane, check spherical support for existence of side plays. If there are side plays of spherical fingers, replace support.
|
GOOD ADVICE
When rocking of the hung-out forward wheel it is difficult to distinguish side plays in bearings of naves and in spherical support. Ask the assistant to press a brake pedal: if in this case feel a side play, then spherical support are faulty.
|
|
|
3. Check rubber plugs and saylentblok in places of fastening of levers to a body.
|
4. Check a condition of rubber plugs of racks of the stabilizer of cross stability...
|
|
|
5. … and also rubber pillows of left …
|
6. … and right fastenings of a bar of the stabilizer to a car body.
|
7. Check a condition of the protection cover of a damping rack.
8. Replace the faulty or damaged details.
|