5-14-8-snyatie-i-ustanovka-toplivnojj-rampy.html
5.14.8. Removal and installation of a fuel stageThe fuel stage is removed for replacement at damage (breakage of unions), for replacement of nozzles or for receiving access to other knots.
It will be required to you: keys "on 10", "on 12".
NOTE
Need of a detachment of a hose from the fuel filter, but not from a stage is caused by the fact that its detachment from a stage requires special adaptation (see below good advice) which is expedient for using only when replacing a hose or stage.
|
USEFUL TIPS
The tip of a hose of supply of fuel in a stage is fixed on the stage union by a collet clip. For weakening of this clip it is necessary to buy special adaptation or to make it by own efforts as it is described below.
|
Wrap up the stage union a tin strip, having made similarity of the plug …
… move the plug into a hose tip so that it was possible to unclench pads of a collet clip …
… also disconnect a hose tip from the stage union.
|
|
3. Remove a vacuum hose from the fuel pressure regulator union.
|
4. Disconnect a fuel discharge hose from pressure regulator, having squeezed its clamps.
|
|
|
5. Move a clamp of a block of a plait of wires of a nozzle up …
|
6. … also disconnect a block. Similarly disconnect blocks of a plait of wires from other nozzles and take a plait of nozzles aside.
|
|
|
7. Turn out two bolts of fastening of an arm of a cable of the drive of a butterfly valve to an inlet pipe …
|
8. … also take a cable aside together with an arm.
|
|
|
9. Turn out two bolts of fastening of a fuel stage to an inlet pipe …
|
10. … also remove a stage, taking out nozzles from openings of an inlet pipe.
|
PREVENTION
If at removal of a stage any of nozzles remains in an inlet pipe, surely replace a clamp of this nozzle.
|
NOTE
Replace sealing rings of nozzles new at each removal or dismantling of a fuel stage.
|
12. Establish a fuel stage in the sequence, to the return dismantling and removal, having oiled sealing rings of nozzles engine.
13. Having connected pipelines to a stage, launch the engine and check tightness of connections of pipelines and consolidations of nozzles.
|