5-7-6-zamena-uplotneniya-maslyanogo-kartera.html
5.7.6. Replacement of consolidation of an oil caseThe oil case is established on sealant, any laying in consolidation is absent therefore in case of an oil leak tightening of bolts of fastening of a case will not result in desirable result. It is necessary to remove an oil case and again to establish it on sealant.
Perform work on a viewing ditch, a platform or whenever possible on the elevator.
It will be required to you: a face head "on 10", a key "on 14" (it is desirable cap).
|
|
3. Turn out two bolts forward …
|
4. … bolt of back …
|
|
|
5. … and a bolt of an average of fastenings of a case of the transmission to an oil case.
|
6. Turn out two bolts of fastening of an oil case located in wells in its back part …
|
|
|
7. … and thirteen bolts located outside.
|
8. Separate an oil case from the block of cylinders the screw-driver inserted into a gap between a case and an arm of the block …
|
|
|
9. … also remove a case, having wrung out a reception pipe down.
|
10. Remove old sealant from the privalochny surfaces of the block of cylinders …
|
11. … and oil case. Carefully wipe rags oil from privalochny surfaces.
GOOD ADVICE
Do not degrease the Privalochny surfaces of the block and a case before putting sealant, only carefully remove from them oil. Further it will provide a possibility of easy dismantling of connection.
|
12. Apply sealant on privalochny surfaces and a carving part of bolts of fastening of an oil case.
13. Establish an oil case and evenly cross-wise tighten bolts the moment specified in the appendix 1.
14. Establish all removed details and knots as it should be, the return to removal.
15. Fill in oil in the engine.
PREVENTION
It is possible to launch the engine after replacement of consolidation of an oil case not earlier than in one hour, it is necessary for sealant polymerization.
|
|