6-1-2-snyatie-i-ustanovka-scepleniya.html
6.1.2. Removal and installation of couplingIt will be required to you: a key "on 11", a mandrel for centering of the conducted disk.
2. Holding a flywheel the screw-driver from a provorachivaniye, turn out six bolts of fastening of a casing of a press clutch plate to a flywheel. Weaken an inhaling of bolts evenly: on one turn of a key everyone, passing from a bolt to a bolt on diameter.
NOTE
For descriptive reasons work is shown on the removed engine.
|
3. Remove a casing and the conducted clutch plate.
|
Fig. 6.2. A mandrel for centering of the conducted clutch plate
|
NOTE
For centering of coupling make a mandrel according to fig. 6.2.
|
4. At coupling installation at first establish by means of a mandrel (see fig. 6.2) the conducted disk, then a casing of a press disk and screw bolts of fastening of a casing to a flywheel. Roll bolts evenly: on one turn of a key everyone, passing from a bolt to a bolt on diameter. Moment of an inhaling of bolts of 15 N · m.
5. Remove a mandrel and install the transmission.
|