6.1.5. Replacement of the working cylinder of the drive of switching off of coupling

It will be required to you: a key "on 12", a key hexagon "on 6".

1. Turn out a bolt union and disconnect a hose from the working cylinder. Muffle a hose that brake fluid did not follow.

NOTE Pay attention to existence and a relative positioning of two copper sealing washers. Replace the pressed-out washers at assembly new.

2. Turn out two screws of fastening of the working cylinder to an arm on a coupling case...	3. … also remove the working cylinder.

4. Establish details as it should be, the return to removal, previously having greased with jellied lubricant the interfaced surfaces of a rod of the working cylinder and the lever of a shaft of switching off of coupling.

5. Remove air from system (see. "Pumping of a hydraulic actuator of switching off of coupling").