Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
6.1. Coupling
6.1.1. Features of a design
6.1.2. Removal and installation of coupling
6.1.3. Replacement of a fork and bearing of switching off of coupling
6.1.4. Replacement of the main cylinder of the drive of switching off of coupling
6.1.5. Replacement of the working cylinder of the drive of switching off of coupling
6.1.6. Replacement of a hose and tube of a hydraulic actuator of switching off of coupling
6.1.7. Removal and installation of a pedal of coupling
6.1.8. Pumping of a hydraulic actuator of switching off of coupling
6.2. Transmission
6.3. Drives of forward wheels
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








59d80679


6-1-8-prokachka-gidroprivoda-vyklyucheniya-scepleniya.html

6.1.8. Pumping of a hydraulic actuator of switching off of coupling

If at the pedal pressed against the stop coupling is switched off not completely ("conducts") that is followed by a characteristic gnash of gear wheels at turning on of the reverse gear, perhaps, air got to a hydraulic actuator of switching off of coupling. Remove it with pumping of a hydraulic actuator.
Besides, pumping is carried out when filling a hydraulic actuator with liquid after its replacement or the repair of knots of system connected with its depressurization.
It will be required to you: brake fluid, a hose for pumping, a key "on 10", capacity for the merged liquid.
1. Check the level of working liquid in a tank of the main brake cylinder (a tank the general for both main cylinders) and if necessary bring to norm.
2. Remove a protective cap from the valve for removal of air of the working cylinder of coupling.
3. Put on a hose the valve and lower its end in capacity with a small amount of brake fluid. Ask the assistant to press 4–5 times a pedal of coupling with intervals 2–3 with, and then to hold it pressed. Turn out the valve on 3/4 turns. Liquid with vials of air will follow from a hose in capacity.
4. Wrap the valve and ask the assistant to release a coupling pedal.
5. Repeat operations 3 and 4 several times prior to the beginning of an exit from a liquid hose without vials of air.

    
PREVENTION
During pumping of a hydraulic actuator periodically check liquid level in a tank of the main cylinder of coupling. Do not allow falling of level of liquid in a tank below a tag of "MIN" on a tank wall. In due time add liquid, otherwise at drainage of a bottom of a tank will get to system air and pumping it is necessary to repeat anew.

6. Wrap the valve, put on a protective cap and if necessary add liquid in a tank of the main cylinder of coupling.

"previous page
6.1.7. Removal and installation of a pedal of coupling
following page"
6.2. Transmission