6-2-13-snyatie-ustanovka-i-remont-kulisy-rychaga-upravleniya-korobkojj-peredach.html
6.2.13. Removal, installation and repair of the coulisse of a control lever transmissionIf after repair or replacement of the drive of gear shifting vibration of the lever of gear shifting at the movement remains, so there is a raised side play in hinges of the lever and they need to be repaired.
It will be required to you: keys "on 12", "on 14", a face key "on 10", the screw-driver.
|
|
1. In a motor compartment weaken a nut of a bolt of klemmovy connection of a tip of the lever and draft of gear shifting.
|
2. Remove the coupling coupling from draft …
|
|
|
3. … and protective cover.
|
4. In salon take from a forward part of facing of a tunnel of a floor a control lever cover frame the transmission, overcoming effort of its clamps.
|
5. Turn a lever cover inside out, have a bite bokorezam (or knife) a collar of fastening of a cover and remove a cover from the lever.
NOTE
Collar of fastening of a cover of the lever of gear shifting of one-time use. At assembly establish a new collar.
|
|
|
7. Unfasten an axis clamp from the lever …
|
8. … also remove a lever axis, taking it from openings of the lever and the coulisse.
|
|
|
9. Having pulled up, remove the gear shifting lever.
|
10. Push the screw-driver in the lever case the rezinoplastmassovy directing plug and advance it lengthways on a shaft.
|
|
|
11. Turn out four bolts of fastening of the case of the lever to the body basis.
|
12. Remove the case and take from it a shaft.
|
13. Remove the directing plug from a shaft.
14. Examine the removed details. If the opening of the directing plug is worn out or its rubber massif is deformed or hardened, replace the plug assembled. If in hinges of the coulisse there is a side play or the opening under a lever axis is worn strongly out, replace the coulisse.
15. Establish details in the sequence, the return to removal.
|