6-2-5-snyatie-i-ustanovka-korobki-peredach.html
6.2.5. Removal and installation of the transmissionIt will be required to you: keys "on 12", "on 14", "on 19".
|
|
4. Mark in any way (for example, paint) a relative positioning of draft and a tip of the lever of gear shifting to keep adjustment of the drive at the return installation of a box.
|
5. Weaken an inhaling of a bolt of a klemmovy clip of the drive of control of the gear shifting mechanism...
|
|
|
6. … also separate draft and a tip of the lever of gear shifting.
|
7. Disconnect blocks of a motor plait of wires from the speed sensor …
|
|
|
8. … and from the backing light switch.
|
9. Turn off two nuts of bolts of fastening of an arm of the working cylinder of coupling, holding the lower bolt from a provorachivaniye the second key.
|
10. Take aside the working cylinder of coupling assembled with an arm and a hose.
|
|
11. Establish a support under an oil case of the engine, using a board piece as a pro-rate.
|
12. Establish a support under the transmission and turn out three bolts of fastening of an arm of the left forward support of a suspension bracket of the power unit to the transmission.
|
|
|
14. Turn out two bolts of fastening of a box to the block of cylinders under a water distribution pipe …
|
15. … the bolt located near an oil filter …
|
|
|
16. … and four bolts (on a turn-key basis "on 14") fastenings of an oil case to a transmission case.
|
17. Turn out bolts of fastening of a case of the transmission to the block of cylinders of the engine, close to a starter …
|
18. … and near a transmission case eye for fastening of an arm of the working cylinder of coupling.
20. … also remove the transmission from the car together with a back support of a suspension bracket of the power unit.
PREVENTION
Not to opirayta the end of a main shaft on petals of a press spring of coupling not to deform them.
|
21. Install the transmission as it should be, the return to removal.
GOOD ADVICE
Before installation of the transmission apply a thin film of jellied lubricant on a shlitsevy part of a main shaft.
|
|