6-3-3-snyatie-i-ustanovka-privodov-perednikh-koles.html
6.3.3. Removal and installation of drives of forward wheelsDrives of forward wheels are removed for their replacement at damage or for replacement of hinges. Besides, drives of forward wheels should be removed for receiving access to other units.
It will be required to you: a key "on 19", a face head "on 32", a dynamometer key, a key for bolts of wheels, the screw-driver with a flat edge, a stripper of spherical hinges, an assembly shovel.
1. Weaken an inhaling of a nut of a nave of a forward wheel.
2. Weaken an inhaling of bolts of fastening of a wheel, then lift a forward part of the car and establish on reliable support.
|
|
3. Remove a wheel, turn off a nave nut …
|
4. … also remove a persistent washer, having hooked the screw-driver.
|
|
|
|
6. Take a telescopic rack aside a little and take a shaft of the external hinge of equal angular speeds from a nave.
|
GOOD ADVICE
If it is not possible to take a hinge shaft by effort of hands, beat out it from a nave easy blows of the hammer through a wooden pro-rate.
|
NOTE
At removal of the drive the effluence of a part of oil from the transmission therefore prepare capacity for collecting oil is possible.
|
|
|
7. Having rested an assembly shovel against a transmission case through a wooden pro-rate, a vypressuyta the internal hinge of the drive from a semi-axial gear wheel …
|
8. … also remove the drive of a forward wheel assembled.
|
PREVENTION
Replace a lock ring of a shaft of the internal hinge with a new ring at each removal of the drive from the car.
|
9. Install the drive and the removed details as it should be, the return to removal. Finally tighten a nave nut on the car standing on the earth, the moment specified in the appendix 1.
10. After an inhaling stop a nut with small beards and the hammer.
11. The second drive is replaced similarly.
|