Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.1.1. Features of a design
7.1.2. Possible malfunctions of a forward suspension bracket, their reason and ways of elimination
7.1.3. Removal and installation of a damping rack
7.1.4. Repair of a damping rack
7.1.5. Replacement of the top support of a damping rack
7.1.6. Replacement of a spherical support of a damping rack
7.1.7. Replacement of the lever of a forward suspension bracket
7.1.8. Replacement of details of the stabilizer of cross stability of a forward suspension bracket
7.1.9. Replacement of the bearing of a forward nave
7.2. Back suspension bracket
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








59d80679


7-1-9-zamena-podshipnika-perednejj-stupicy.html

7.1.9. Replacement of the bearing of a forward nave

It will be required to you: stripper of bearings, stripper of lock rings, small beards, hammer
    
GOOD ADVICE
For replacement of the bearing it is convenient to use the stripper which is available on sale for a vypressovka and a press fitting of bearings of naves.
    
NOTES
It is more convenient to carry out replacement of the bearing of a forward nave on the damping rack removed from the car.
We recommend to replace bearings of both naves of forward wheels at the same time.

1. Remove a damping rack of a forward suspension bracket (see. "Removal and installation of a damping rack").
2. Clamp a rack in a vice and beat out a nave the hammer, using a mandrel of suitable diameter (for example, a face head).
3. Remove a nave. Most likely, on a nave there will be an external half of an internal ring of the bearing.
    
PREVENTION
After removal of a nave the bearing is not suitable for reuse therefore it should be replaced.

4. Use a stripper …
5. … to remove it from a nave.
6. Easy blows of the hammer through a mandrel besiege the bearing in a fist nest to release a lock ring.
7. Remove a lock ring of the bearing a stripper of lock rings.
8. Similarly remove the second ring.
9. Establish a stripper of bearings, a vypressuyta …
10. … also take the bearing from a fist.
11. In the absence of a stripper beat out the bearing, using a mandrel of suitable diameter as the vypressovanny bearing is not subject to reuse.
12. Clear details and grease an internal surface of a nest of a fist and an external surface of a nave with a thin layer of Litol-24 lubricant.
13. Establish an internal lock ring.
14. Press the new bearing against the stop in a lock ring.

PREVENTION
At a bearing press fitting in the case of a rotary fist the effort should be put to an external ring of the bearing, otherwise the bearing can be damaged.

15. Establish an external lock ring in a fist nest flute.
16. Press a nave in the bearing against the stop, having recorded a support an internal ring of the bearing.
    
PREVENTION
If at a press fitting of a nave not to record a support an internal ring of the bearing, then it can be damaged.

17. Install a damping rack on the car as it should be, the return to removal.
18. Check and if necessary adjust the angles of installation of wheels. Use services of the workshops having the special equipment.

"previous page
7.1.8. Replacement of details of the stabilizer of cross stability of a forward suspension bracket
following page"
7.2. Back suspension bracket