7-2-4-zamena-pruzhiny-zadnejj-podveski.html
7.2.4. Replacement of a spring of a back suspension bracketReplace a spring at mechanical damage or considerable draft. Draft signs:
– deterioration in smoothness of the course, frequent "breakdowns" of a suspension bracket;
– the visible distortion of a back part of the car or a considerable difference on height of forward and back parts which arose in use;
– strongly expressed traces of impact of rounds of a spring.
NOTE
Replace springs in a set (left and right at the same time).
|
You will need a key "on 17".
GOOD ADVICE
It is more convenient to perform work on the elevator and with the assistant.
|
1. If you replace springs on the elevator, establish under a beam of the back bridge of a support and lower the car, having slightly loaded a suspension bracket. During the work on a viewing ditch this operation is not required.
PREVENTIONS
You do not take the shock-absorber aside on distance bigger, than it is necessary for work, in order to avoid a rod bend.
Do not disconnect at the same time both lower fastenings of shock-absorbers from a beam of a back suspension bracket.
|
3. Lift the car to unload a spring, and remove a spring 1 and the top laying 2. As a rule, length of a brake hose 3 is enough that it did not stretch, but if you see that the hose stretches, disconnect it for the period of replacement of a spring not to damage (see. "Replacement of brake hoses").
PREVENTION
Carry out removal and installation of a spring extremely carefully in order to avoid launching of a spring from a suspension bracket and getting injured.
|
4. Remove the lower laying of a spring from the platform on a beam of a back suspension bracket.
PREVENTION
Replace the damaged laying of a spring new.
|
5. Install a spring with laying on the car as it should be, the return to removal. Replace the second spring similarly, but only after fixing of the lower end of the shock-absorber disconnected when replacing the first spring.
|