7-2-7-zamena-podshipnikov-zadnejj-stupicy.html
7.2.7. Replacement of bearings of a back naveIt will be required to you: a face head "on 24", flat-nose pliers, the screw-driver with a flat edge, small beards, a stripper for a bearing vypressovka, a universal stripper.
1. Weaken an inhaling of bolts of fastening of a wheel.
2. Include the I transfer and establish an emphasis under forward wheels. Raise and establish a back part of the car on reliable support.
3. Remove the corresponding wheel.
|
|
|
5. Take an epiploon, having hooked it the screw-driver.
|
GOOD ADVICE
Replace an epiploon new at each removal.
|
|
|
6. Take out an internal ring of the internal bearing from a nave.
|
7. Using the hammer and small beards, beat out and take out an external ring of the external bearing from a nave.
|
NOTE
For a vypressovka in the case of a nave of the brake drum two grooves are executed (on a photo one is visible, the second is located diametrically).
|
8. Similar to a vypressuyta an external ring of the internal bearing.
NOTE
For a vypressovka in the case of a nave of the brake drum two grooves are executed (on a photo one is visible, the second is located diametrically).
|
9. Clear an internal cavity of a nave and a pin of old lubricant. On landing surfaces under bearings on a pin and a nave there should not be wear tracks, chips, забоин, zadir. With the specified defects replace the damaged details.
10. Grease an internal cavity of a nave and a pin with lubricant for Litol-24 bearings or its import analog (Hytex EP-2 of Texaco, Mobilux 2, 3, EP2, EP3, Mobilgrease MP of Mobil, Energrease L2, LS3 of British Petroleum, etc.).
|
|
11. Press in a nave an external ring of the internal bearing a mandrel of suitable diameter.
|
12. Put lubricant in a nave cavity.
|
13. Similarly press an external ring of the new external bearing in a nave.
14. Establish previously greased internal ring of the internal bearing in a nave …
15. … also press an epiploon.
NOTE
Before installation of an epiploon grease its working edge with jellied lubricant.
|
|
|
16. Install the brake drum on a pin.
|
17. Establish an internal ring of the external bearing.
|
18. Establish a washer and a nut of a nave.
19. Establish a wheel.
|