9-11-3-zamena-zadnego-trosa-privoda-stoyanochnogo-tormoza.html
9.11.3. Replacement of a back cable of the drive of the parking brakeReplace a back cable of the drive of the parking brake at its excessive pulling (impossibility of adjustment of the parking brake), mechanical injuries of veins of a cable or its cover.
NOTE
Each brake mechanism of back wheels is given by a separate cable. Removal and installation of the left cable are shown. The right cable is removed and established similarly.
|
It will be required to you: a key and a face head "on 10", the screw-driver with a flat edge, passatizh.
|
|
2. Disconnect a tip of a back cable of the drive from the equalizer, having brought him out of an equalizer cut.
|
3. Having turned off fastening nuts, remove the supporting cable arm on a guard of the fuel tank …
|
|
|
4. … then forward …
|
5. … and back holders on a body …
|
|
|
6. … and also the holder on the lever of a back suspension bracket.
|
7. Having hooked the screw-driver, take the adjusting plug of a cover of a cable from an arm on the basis of a body …
|
8. … also take out a cable from an arm opening.
|
|
10. Wring out the screw-driver razzhimny the lever forward …
|
11. … and passatizham disconnect a cable tip from the razzhimny lever.
|
|
|
12. Remove a spring clamp of a cover of a cable from a reverse side of a board of a brake …
|
13. … and, having extended a cable through an opening in a board, remove it from the car.
|
14. Establish a back cable of the drive of the parking brake as it should be, the return to removal.
|