9-5-1-zamena-bachka-glavnogo-tormoznogo-cilindra.html
9.5.1. Replacement of a tank of the main brake cylinderYou will need the screw-driver.
1. Disconnect a wire from the minus plug of the rechargeable battery.
|
|
2. Having unclenched clamps, disconnect a block of a plait of wires from a stopper of a tank of the main brake cylinder.
|
3. Turn off a stopper of a tank of the main brake cylinder.
|
|
|
4. Pump out brake fluid from a tank, for example, the big medical syringe.
|
5. Weaken a collar of fastening of a hose to the main cylinder of switching off of coupling, shift a collar on a hose …
|
6. … also disconnect a hose from a tank of the main brake cylinder.
GOOD ADVICE
At once after a hose detachment from a tank muffle its opening, without lowering a hose down. At the same time in a hose there will be a quantity of working liquid therefore after installation of a tank and accession of a hose to it it will not be required to delete air from a coupling switching off hydraulic actuator.
|
|
|
7. Having hooked the screw-driver, remove a tank, taking its branch pipes from connecting plugs.
|
8. If leak of brake fluid via connecting plugs was in use observed, take plugs from cylinder case openings.
|
PREVENTION
Reuse of connecting plugs is not allowed, replace them new.
|
9. Before installation of a tank insert connecting plugs into openings of the main brake cylinder. Then install a tank, having inserted its branch pipes into connecting plugs by effort of a hand against the stop.
GOOD ADVICE
For simplification of installation of connecting plugs in the cylinder and tank branch pipes in plugs moisten them with fresh brake fluid.
|
|
|