Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of the brake system, their reason and ways of elimination
9.3. Pumping of a hydraulic actuator of the brake system
9.4. Check and adjustment of provision of a pedal of a brake
9.5. Main brake cylinder
9.5.1. Replacement of a tank of the main brake cylinder
9.5.2. Replacement of the main brake cylinder
9.5.3. Replacement of regulators of brake forces
9.6. Vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydraulic actuator of brakes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.10. Brake mechanisms of back wheels
9.11. Parking brake
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








59d80679


9-5-3-zamena-regulyatorov-tormoznykh-sil.html

9.5.3. Replacement of regulators of brake forces

Replace regulators of pressure only with a set (2 pieces). Marking of the regulator 3/30.
When replacing install regulators only with the same marking.
It will be required to you: keys "on 10" (a special key for nuts of fastening of pipelines), "on 21", "on 22".
1. Turn off a nut of fastening of the pipeline, holding a regulator stopper from a provorachivaniye the second key …
2. … also take the pipeline aside.
3. Before removal of the faulty regulator (the back wheel is blocked before lobbies or along with them) check purity of its working camera. For this purpose weaken a regulator stopper inhaling, holding the regulator from a provorachivaniye the second key...
4. … also turn out a stopper together with a spring and a plunger. Clear regulator details of pollution, wash out them fresh brake fluid and establish into place. Remove air from system (see. "Pumping of a hydraulic actuator of the brake system", page 187) and again check overall performance of the regulator.
5. If operability of the regulator was not restored, replace both regulators with a set. Having disconnected from the regulator the pipeline (see subitems 1 and 2), weaken pressure regulator inhaling...
6. … also turn out the regulator from the case of the main brake cylinder.

    
PREVENTION
Replace a sealing ring of the regulator of pressure at each dismantling of connection new.

7. Similarly remove the second regulator of pressure.
8. Install pressure regulators as it should be, the return to removal, and remove air from a hydraulic actuator of the brake system (see. "Pumping of a hydraulic actuator of the brake system").

"previous page
9.5.2. Replacement of the main brake cylinder
following page"
9.6. Vacuum amplifier of brakes