9-7-1-zamena-tormoznykh-shlangov.html
9.7.1. Replacement of brake hosesOn the car apply four brake hoses: two (back) for connection of pipelines on a beam of a back suspension bracket and two (lobbies) for connection of pipelines with working cylinders of forward brake mechanisms.
It will be required to you: keys "on 10", "on 12", "on 19", passatizh.
GOOD ADVICE
Apply special keys as nuts are strongly tightened and usually korrodirovana owing to what when using of usual keys of a side of nuts are rumpled to an otvorachivaniye of nuts of tubes.
|
|
|
1. For removal of a forward hose turn off a nut of fastening of a tube, holding the top tip of a hose from a provorachivaniye …
|
2. … also disconnect a tube.
|
GOOD ADVICE
For prevention of a full effluence of liquid from a hydraulic actuator at once muffle a tube opening in any available way. Very well protective caps of valves for production of air are suitable for this purpose.
|
|
|
3. Remove a locking bracket from the top tip of a hose.
|
4. Turn out a bolt union of fastening of the lower tip of a hose to the working cylinder of the forward brake mechanism …
|
NOTE
Pay attention to two copper sealing washers …
… located on both sides of a hose tip. At assembly replace these washers new.
|
5. … also remove a brake hose.
6. Establish a new hose as it should be, the return to removal.
PREVENTION
Track that the hose was not overwound at installation along an axis.
|
7. Similarly replace the second forward hose.
8. Back brake hoses have the tips similar to the top tip of a forward hose. Replace these hoses, using the same receptions and tools, as for lobbies.
|